Warehouse Storage Push Back Pallet Rack With Special Gravity
Dustproof
Push Back Pallet Rack Introduction
Push back rack is a first-in-last-out storage system, suits for
unified pallet goods. Push back rack system is a high density
storage system. It can make most use of the warehouse space. In the
same area, push back rack can store many more goods comparing with
conventional pallet rack.
Push Back Pallet Rack Features & Benefits
1) Individual access to all pallets to full height of warehouse;
2) Elegant appearance, sturdy and durable;
3) The system is also speedily installed and simple to adjust;
4) The beam levels are adjustable by 75mm;
5) Lower level pallets can be located on the floor (picking
pallets;
6) Accessories available can accommodate every unit load type.
Push Back Pallet Rack Features
• First-in-last-out mode
• Large storage capacity and extremely high space utilization
• Suitable for multiple varieties and large quantities of goods
• Suitable for situations such as freezer that need to greatly
improve space utilization
Push Back Pallet Rack detail
Cart - Bearings – Rails – Anti-Slip Steel – Rail Bracket – Front
Stopper
Push Back Pallet Rack function
Push-back rack, also known as push-in rack, are connected by
multi-layer carts between the front and rear beams. Stacked goods
are pushed into the carts from the outside, and the stored goods
will push the original goods into it. It is usually used in places
where the storage space is extremely limited, but the storage
capacity must be increased or the time required for the goods must
be increased.
The track of the press-in rack has a certain slope, about 3 °. It
uses the weight of the goods, and the pallet goods are specified
for single-end storage. The total depth of this kind of rack should
not be too deep, generally within the depth of 6 pallets, because
the carts are embedded in each other, so they take up some space.
The weight of a single pallet is generally within 1500kg, and the
rack height is generally below 6m.
The press-in racking system has higher requirements for the
manufacturing accuracy of the rack. Because the cooperation between
the pallet cart and the guide rail is high, the manufacturing and
installation accuracy is strict. Failure to do so will cause the
racking system to run poorly and affect work effectiveness.
The cost of press-in rack is higher, which is directly proportional
to its value. Its warehouse utilization rate reaches about 80%, and
the space utilization rate of the warehouse can be improved.
It is more than 30% high, easy to access and flexible, and is the
rack with the highest storage efficiency.
Design Features
The track of the press-in rack has a certain slope, about 3 °. It
uses the weight of the goods, and the pallet goods are specified
for single-end storage. The total depth of this kind of rack should
not be too deep, generally within the depth of 6 pallets, because
the carts are embedded in each other, so they take up some space.
The weight of a single pallet is generally within 1500kg, and the
rack height is generally below 6m.
